Tohnichi T-FHM - User Manual

Questions and Answers

A
Anthony FrenchAug 9, 2025
Why is the receiving distance short on my Tohnichi T-FHM?
- H
  haileyhollandAug 9, 2025
  A short receiving distance on your Tohnichi Power Tool can be caused by several factors. First, ensure the receiver's antenna is correctly installed. If you aren't using a double antenna, consider doing so. Also, the receiver's location matters; move it if it's near metal poles or iron piping. Obstructions between the transmitter and receiver can also cause this, so relocate either the shield or the receiver. Finally, radio wave environment issues can be a factor, so try changing the group.
M
Michael FloresAug 14, 2025
What to do if the communication status check LED flashes red 3 times on my Tohnichi Power Tool?
- M
  moorerandallAug 14, 2025
  If the communication status check LED flashes red three times after activating your Tohnichi Power Tool, the issue could stem from a few reasons. Check the settings on the setting BOX and reset any incorrect settings. Verify that the Receiver is powered on. Also, radio wave environment problems might be the cause, so try changing the group.
V
vmosleyAug 25, 2025
What to do if the communication status check LED does not light up on my Tohnichi Power Tool?
- K
  Kimberly AliAug 25, 2025
  If the communication status check LED on your Tohnichi Power Tool doesn't light up after activation, there could be several reasons: * The battery might be dead. Check the remaining battery life and replace it if the LED is red. * There might be no battery in the case. Place a battery in the case. * The switch function might be abnormal. If the LED is blue, there could be a problem with the switch function, and the tool may need repair.
L
Laura SuarezAug 29, 2025
Why can't I change the settings on my Tohnichi Power Tool?
- H
  Hannah SandersAug 29, 2025
  If you cannot change the settings on your Tohnichi Power Tool, it might be because the unit is not in setting mode. Press the SET switch for 1 second to enter setting mode. Alternatively, multiple models might be set in setting mode. Ensure only one model is in setting mode.
S
Scott RaySep 3, 2025
Why does the LED light up when the Tohnichi T-FHM wrench is not activated?
- W
  walter17Sep 4, 2025
  If the LED on your Tohnichi Power Tool lights up or flashes even when the wrench is not activated, it likely means the battery is low. Replace it with a new one.
A
Anthony BeckSep 10, 2025
How to fix unstable receiving status on my Tohnichi Power Tool?
- M
  Mr. Joseph JohnsonSep 12, 2025
  An unstable receiving status on your Tohnichi Power Tool may be due to an improper setting of the double tightening prevention timer. Readjust the timer. Also, radio wave environment problems might be the cause, so try changing the group.