corresponding jacks.
Turn on the stereo/amplifier system (if applicable). Select the
correct output in the setup menu.
Remove and clean the disc
Some distortion may occur during the FORWARD and REWIND
operations. This is normal.
Flickering or unstable
brightness
Connect the player directly to your TV
NOTE: Disruptions can be caused by copy protection systems
on a discs
The player does not
operate
Be sure that a disc is loaded
Be sure that the disc is compatible (check the disc' s
format and color signal coding standard)
Check that the disc is correctly loaded
Clean the disc
Be sure that the Discs player settings are correct
No response when
buttons are pressed
Switch player, unplug the power cord, and then plug in the power
cord and switch it on again.
The remote controller
does notwork
Point the remote controller at the sensor.
Check that the remote control is no more than 20 feet from
the sensor.
Replace the batteries with new batteries.
If you have any questions about the product, please contact us through Amazon, we
will continue to serve you
Thank you for purchasing from Maxesla!
To Next Page
Loading...