Tomahawk TMD14 - Operation: Start-Up Completion; Engine Start-Up Procedures; Engine Stopping Procedures

4.1 Start Up Guide Continued
4.2 Stopping the Engine
4.2.1 Move the water valve to the closed position to stop the flow of liquid pesticide.
See Figure 1&2.
4.2.2 Move the throttle lever to the down position (O) to stop the engine. See Figure 2&3.
4.2.3 Ensure the choke is in the the closed position. See Figure 4.
11
4
To prime the engine, press the carburetor bulb
4-5 times or until fuel runs through the lines.
3
Move the choke to the up position.
6
Once the engine fires up, slowly move the
choke to the down position.
5
Pull the recoil starter cord until the engine
turns over and starts.
FIGURE 1 FIGURE 2 FIGURE 3 FIGURE 4