Quick Start
- 10 -
1. Turn on the drone and place it on a horizontal surface.
2. Turn on the power of the remote control, and it will make a beep.
Afterwards, the remote control emits two beeps, indicating that the
linking is successful.
1. During calibration, the remote control beeps, the drone indicators flashes
quickly, and the calibration complete indicator light is always on.
2. When the drone crashes, please recalibrate it.
Use the screwdriver to press down to the position shown in the figure, and
open the battery cover to install the battery (not included).
Push the two control sticks downwards outward 45° together.
Tips:
Frequency matching
Calibration
Install the remote control battery
To Next Page
Loading...
