Headless Mode(Short press)
One-button Return(Long press)
One-key Take off / land(Short press)
Emergency Landing(Long press)
Power Switch
Throttle Joystick / Speed
Gear(Press down the
middle key)
Photo Taking
Video Recording
Fine Tuning
Direction Joystick
Flip(Press down
the middle key)
Battery Installation
Introduction of transmitter
Open the battery on the back of remote controller. Insert 3 * AA 1.5V batteries in accordance with
the instructions on battery box.(Battery should be purchased separately, old and new or different
types of batteries shouldn’t be mixed.)
Battery Charging
Please use the packaged charging cable to charge the battery. When charging the indicator light
red, and light off when the battery is fully charged. The full charging time takes about 120 minutes.
Charging Saftey Notes
* Different types of batteries or new and old batteries shall not be mixed.
* Non rechargeable batteries shall not be charged;
* Only the charger provided shall be used for charging.
* Install the battery power terminal according to the correct polarity
without short circuit.
* Non rechargeable batteries cannot be charged, and rechargeable
batteries can only be charged under adult supervision.
Do not use the charged battery when charging, and do not leave when
charging.
* The U.S. Environmental Protection Agency says the batteries are
used.
To Next Page
Loading...
