Tone Commander 8610/8620 User Guide 25
Setting Up Multifunction Keys
From the User Options menu, you can enter key labels, set up Speed
Dial and DSS keys, and enable call origination for Feature Activator
keys.
Call Appearance and Feature Activator keys must be assigned by a
Parameter Download or from the Installation Options menu.
From the User Options menu, select KEYS.
(
SETUP → USER
→ KEYS)
The status indicator for each key will indicate the current
setting:
Green – Call Appearance or DSS
Red – Feature Activator
Off – Unused or Speed Dial
On the phone or Button Expansion Module, press the
multifunction key to be programmed.
The selected key’s indicator will alternately flash red and
green.
The following key settings can be changed from the User Options
menu:
Call Appearance/DSS – select CA/DN or Direct Station
Selection mode, enter a dialing string for DSS.
Feature Activator – add a CALL option to originate a call
when sending the Feature Activator code.
Speed Dial – enter a dialing string for one-button speed
dialing.
Programming procedures for each key type are described below.
To Next Page
Loading...
