ASSEMBLY AND USE
Installation
Always take care when removing the packaging to prevent
damage to you or to the lawnmower.
Before assembling the lawnmower, check all the parts
indicated in the manual are in the box. Inspect all the parts
for signs of damage. Do not assemble the lawnmower if you
observe any damaged components.
1. Remove the packaging
1a. Remove all parts of the lawnmower from the box and
carefully remove all packaging. Take care not to lose any
instructions which may be attached to the parts. These
provide important information which will be required while
assembling the lawnmower.
1b. Keep all packaging until the lawnmower is fully assembled
and has been operated successfully.
Always recycle the packaging in accordance with local
recycling schemes. This item requires a two person lift to
remove from the packaging.
Make sure that you have sufficient space to put the lawn
mower down. Keep your feet apart so that you have a stable
position, bend at the knees and keep your back straight.
2. Assemble the lower handle
2a Remove the packaging from the handle. Set the height
adjustment to the highest position, and align the lower
handle with the holes in the deck. Make sure the holes in the
lowerhandle are aligned with those in the support.
2a
To Next Page
Loading...
