NOTE!
Do not fill into the base of the tank neck to allow for fuel
expansion. Do not overfill the fuel tank.
NOTE!
Petrol is highly flammable and extreme precaution must be
taken when handling or working with it. Keep out of reach of
children.
NOTE!
To prevent engine damage the engine is shipped without oil
or petrol. The engine must be filled with the correct grade of
oil and petrol before starting the engine.
NOTE!
Refuel in a well-ventilated area with the engine stopped. Do
not smoke or allow flames or sparks in the area where the
engine is refueled or where petrol is stored. Avoid repeated
or prolonged contact with your skin or inhalation of vapour.
Clean the area around the petrol filler cap before removing
the cap. Remove the warning tag, check the fuel level.
Refill the tank if the fuel level is low (fuel tank capacity is 0.8 L).
Refuel carefully to avoid overfilling or spilling fuel. There
should be no fuel in the filler neck.
Clean up any overflow or splashes of petrol before starting
the engine.
Tighten the filler cap after filling, finger tight only.
NOTE!
Do not use wasted or regenerated oil that can cause damage
to the engine.
Operation
1. Setting the Cutting Height
NOTE!
The blade can cause serious injury. Before adjusting the
mower height, stop the engine and wait for the mower blade
to stop completely.
Pull the lever towards the wheel, then move it forwards or
backwards to adjust the cutting height. Move it to any one
of the 7 positions (25~75mm) for the desired cutting height;
Ensure the lever clicks into place.
To Next Page
Loading...
