Pull cord handle
With right hand, slowly but firmly pull the starter handle and
rope from the pull cord guide until you feel resistance, then
pull briskly. When the engine starts, return the starter rope to
its rest position gently.
Loose the Start/Stop bar forward you.
Clearing a flooded engine:
If the engine won’t start after you have trying to start several
times, the engine may be flooded with excess fuel.
Use the following procedure to clear and start a flooded
engine:
A. Release the stop/start bar.
B. Remove the spark plug, dry it, and then reinstall it.
Install the spark plug carefully by hand, to avoid cross
threading.
After the plug is seated, tighten 1/8 to 1/4 turn with the spark
plug socket spanner to compress the washer.
C. Press down the primer for 3 times.
D. Pull the stop/start bar toward the upper handle.
E. Operate the starter as described above.
3. Mowing
NOTE!
Always observe the strictest safety procedures when using
the lawnmower.
Carefully read the safety instructions of this manual before
using the lawnmower.
Start the engine and allow it to run. See ”Step-2 Starting the
11b
11a
To Next Page
Loading...
