Top Flite Stinson Reliant User Manual

WARRANTY.....Top Flite Models guarantees this kit to be free of defects in both material and workmanship at the date of purchase. This warranty does
not cover any component parts damaged by use or modification. In no case shall Top Flite‘s liability exceed the original cost of the purchased kit. Further, Top Flite reserves
the right to change or modify this warranty without notice. In that Top Flite has no control over the final assembly or material used for final assembly, no liability shall be assumed
nor accepted for any damage resulting from the use by the user of the final user-assembled product. By the act of using the user-assembled product the user accepts all
resulting liability. If the buyer is not prepared to accept the liability associated with the use of this product, the buyer is advised to immediately return this kit in new and
unused condition to the place of purchase.
Top Flite Models P.O. Box 788 Urbana, Il 61803 Technical Assistance Call (217)398-8970 productsupport@top-flite.com
READ THROUGH THIS INSTRUCTION BOOK FIRST. IT CONTAINS IMPORTANT INSTRUCTIONS AND WARNINGS CONCERNING THE ASSEMBLY AND USE OF THIS MODEL.
U
SA
M
ADE IN
STNGP03 V1.0
Entire Contents © Copyright 1999
Wingspan: 100.5" [2553mm]
Wing Area: 1487 sq. in. [95.9 sq. dm]
Weight: 16 - 25 Lbs. [7258 - 11340g]
Wing Loading: 24.8 - 38.7 oz./sq. ft.
[75.7 - 118.1 g/sq. dm]
Fuselage Length: 67.8 in. [1722mm]

Top Flite Stinson Reliant Specifications

General

Brand	Top Flite
Model	Stinson Reliant
Category	Toy
Language	English

Summary

Warranty Information

Safety and Precautions

Follow Important Safety Precautions

Crucial safety guidelines for assembling and operating the model.

Precautions

Model Decisions

Engine Selection

Recommended engine sizes for the Stinson Reliant model.

Building the Tail Surfaces

Build the Stabilizer

Step-by-step instructions for constructing the horizontal stabilizer.

Build the Elevators

Hinge the Elevators

Build the Fin

Build the Rudder

Building the Wing

Preliminary Assembly

Frame the Panel

Instructions for framing a wing panel, including spars, joiner box, and ribs.

Build the Aileron

Build the Flap

Mounting Wing Servos

Control Linkages

Building the Fuselage

Build the Formers

Detailed instructions for building the fuselage formers accurately.

Build the Bottom of the Fuselage

Steps for assembling the bottom half of the fuselage over the plans.

Add the Tops of the Formers

Building the Front of the Fuselage

Add the Stab Saddles

Mounting the Landing Gear

Final Construction Steps

Mount the Engine

Guide for mounting the engine, including alignment and extension box.

Mount the Stab and Fin

Instructions for mounting the horizontal stabilizer and vertical fin.

Mounting the Wing

Mounting the Servos

Fuselage Sheeting

Fuselage Details

Make Windows and Doors

Landing Gear Construction

Cowl Installation

Finishing the Front Cabin

Model Preparation for Covering

Finishing Processes

Painting Procedures

Lateral Balance Adjustment

Covering the Model

Final Model Assembly

Preparing for Flight

Balancing the Model

Critical steps for balancing the model for stable flight.

Final Hookups and Checks

Control Surface Throws

Pre-Flight Checks

Range Check Your Radio

Checklist for Flight Preparation

Engine Safety

Engine Safety Precautions

Essential safety rules for operating model engines.

AMA Safety Code Excerpts

Key safety rules from the Academy of Model Aeronautics.

Flying the Stinson Reliant

Takeoff Procedures

Detailed instructions for taxiing and performing the initial takeoff.

Flight Characteristics

Landing Procedures

Instructions for landing the model, with and without flaps.