13
mast (...)
Then feed end of spinnaker halyard through the small pulley
at the top of the mast (8).
Attach striker bar (9) (front cross bar) between the hulls at
the front of boat.
ENSURE THAT THE STERN OF THE BOAT IS FACING INTO
THE WIND. ENSURE THAT THE MAST IS CLEAR OF ANY
OVERHEAD CABLES OR OBSTRUCTIONS!
Re-tidy all of the rigging.
You are now ready to raise the mast. This is a two person job.
Take spinnaker halyard to foot of mast tying ends together to
create a loop.
Position mast so that the foot of the mast is on the ball joint
on the front beam and secure in place with pin.
5
7
8
6
To Next Page
Loading...
