5
rigging instructions
beams
trampoline
This will hold the hulls in the correct position to connect to
the main and rear beam.
8 x lock nuts, washers and 8mm x 15mm s/s bolts are
supplied.
You wll require assistance to bolt the beams into the hulls.
snugly into the front socket of the hulls. The rear beam is
smaller with a traveller attached and a row of small plastic
into the rear beam sockets with the white plastic wheels
facing aft.
Feed the bolts into the holes in the hulls going through the
washer and then attach lock nut and tighten.
Remove the beam end cap from the main beam.
Remove slugs from front beam.
1
2
To Next Page
Loading...