Topcom ultra range series - Forwarding a Call to Another Handset; Conference Calls (Two Internal Handsets and an External Caller); Voicemail Display; Repeater (R112 and SR1200 c)

28
5HSHDWHU5DQG65F 8OWUD5DQJH
9.3.4 Forwarding a call to another handset
• You have an external caller on the line.
1. Press ,17 .
2. Press or repeatedly and select the handset you
want to dial.
•Select ‘$//+$1'6(76’ to call all handsets.
• Press to call the selected handset(s). If the called
handset answers and you can conduct an internal call.
3. Press to connect the external caller to the called
handset.
25
• The internal called party does not answer.
4. Press ,17’
again to talk to the external caller again.
9.3.5
Conference calls (two internal handsets and an
external caller)
You can conduct a phone call with an internal and an external party
at the same time.
1. Press ,17 .
2. Press or repeatedly and select the handset you
want to dial.
•Select ‘$//+$1'6(76’ to call all handsets.
3. Press to call the selected handset(s). If the called
handset answers and you can conduct an internal call.
4. Press and hold the ,17 key until you see ‘&21)(5(1&(’ on
the screen
• You are now connected to an external and an internal party
and can talk to both of them at the same time (conference
call).
 9RLFHPDLOGLVSOD\
This display only works if you have enabled the voicemail or
telephone message service and your line provider transmits this
information along with the caller ID!
When you receive a new message in your voicemail box, the
symbol appears in the display. The symbol disappears when
you have listened to your message.
To listen your messages you have to dial a certain number, this
number can be programmed under key ‘1’ (see “4.26 Voicemail
dial key number”).
 5HSHDWHU5DQG65F
A repeater can be used to extend the range between the base
station and handset(s). Up to 6 repeaters can be registered to the
base (see picture 1) and two times 3 repeaters can be put in
cascade (see picture 2) .
12
4 15
17
6
12
12
4 15
17
If you have turned on the Conference function (see “7.3
Easy conference mode”) you can also make a
conference call by just going off-hook on the second
handset when 1st handset is in communication with the
external line.