Chapter 2 Standard Features 11
screen. The display backlight brightness can easily be toggled up or
down in 25% increments from 0% to 100% by tapping the percent
tile (see the sun icon).
Connector Ports
The FC-6000 has a 12 VDC power input jack, USB 3.0 Host type A,
and a 3.5mm audio jack.
Connector Protector
The connector protector is removable and replaceable. To remove
it, pull it out of the ports, then gently pull the curved rubber retainers
out of the holes they are in. Replace it by inserting the curved
rubber retainers back into the holes. See your sales representative if
you need a new one.
Note: The connector protector is not required to maintain the seal
of the connectors or the FC‑6000. The connector protector is
intended as a port dust cover
SD Cards
The FC-6000 has a slot for a micro SD card located in the battery
compartment. The card slot and flexible card holder are designed to
hold the card securely in place so it will not come out or disconnect
if the FC-6000 is dropped. To insert or remove a card, follow these
steps:
1. Power o the FC-6000.
2. Remove the battery door as outlined in Chapter 1.
CAUTION: The FC‑6000 is not sealed against water and
dust when the battery pack and battery door are not installed
properly.
CAUTION: Always power o the FC‑6000 before removing
the battery. Failure to do so may cause loss of data or damage
to the FC‑6000. EXCEPTION: If your FC‑6000 has an internal
battery, this caution does not apply. You can safely remove the
removable battery while the unit is running.
3. Remove the battery pack by pulling up on the black tab on the
battery pack.
!
!
To Next Page
Loading...
Need help?
General
