Chapter 2 Standard Features 13
Compass Calibration
The compass has been factory calibrated. Periodic user calibrations
help the compass function in the environment the FC-6000 is being
used in.
1. Open an app that uses the compass.
2. Move the FC-6000 around in the air so that it is oriented in
dierent directions and angles. An eective way to assure this
is properly done is to move the FC-6000 back and forth in a
sideways figure 8 for approximately 30 seconds.
Bluetooth
®
Wireless Communication
The FC-6000 has built-in Bluetooth
®
wireless technology,
allowing you to connect it to other wireless devices with Bluetooth
technology.
Creating a Partnership/Pairing a Bluetooth Device
To create a partnership between the FC-6000 and another device
with Bluetooth technology:
1. Turn both devices on.
2. Place them within a few feet of each other. (The FC-6000 has
long range Bluetooth, but the other device might not.)
3. Make Bluetooth discoverable on both devices. Bluetooth on the
FC-6000 is o by default. To activate it, open the Action Center
and press and hold the Bluetooth icon. Select Go to settings.
4. In the Bluetooth settings screen, you should see a list of all
Bluetooth devices within range. Tap on the name of the device
in the list you would like to pair with, then tap Pair. If prompted,
enter the PIN or pass code of the paired device. You should
now be paired with the device.
Note: If Bluetooth is on and the FC‑6000 enters sleep or hibernate
mode, Bluetooth turns o to save battery power. The connection is
resumed once it powers back on.
To Next Page
Loading...
Need help?
General
