13
1-866-4TOPCON www.topcongps.com
modem/fh/rcts
This command enables/disables RTS/CTS hardware flow control.
modem/fh/reset
With this command the operator resets the radio modem.
Structure
set,modem/fh/rcts,N
, where N is 0 or 1. Zero
stands for none (i.e., hardware handshaking is
disabled), unity stands for RTS/CTS (i.e., hardware
handshaking is enabled).
print,modem/fh/rcts
Example
set,modem/fh/rcts,1
- activates RTS/CTS
hardware handshaking
print,modem/fh/rcts
Reply to
set %%OK -> rcts=M
- positive acknowledgment,
where M is the current hardware handshaking status
Error in Command
- negative acknowledgment
Error in Argument
- negative acknowledgment
Reply to
print rcts=M
- positive acknowledgment, where M is the
current hardware handshaking status
Error in Command
- negative acknowledgment
Structure
set,modem/fh/reset
Example
set,modem/fh/reset
- performs the reset
procedure
Reply
%%OK -> Reset
- positive acknowledgment, the
modem has been reset
Error in Command
- negative acknowledgment
After executing this command, the modem
reverts to the operating mode. To put the
modem in the command mode, type the +++
command
To Next Page
Loading...
