iv
PROHIBITED: Topcon equipment must not be used by an operator affected by
alcohol or drugs. Seek medical advice if using prescription or over-the-counter medication.
Electrical Safety
WARNING: Incorrectly connected power can cause severe injury and damage to
people or the equipment.
Disclaimer
Topcon accepts no responsibility or liability for damages to property, personal injuries, or death resulting from the
misuse or abuse of any of its products.
Further, Topcon accepts no responsibility for the use of Topcon equipment or the GNSS signal for any purpose other
than the intended purpose.
Topcon cannot guarantee the accuracy, integrity, continuity, or availability of the GNSS signal.
The operator must ensure that the equipment is correctly turned off when not in use.
Before operating any vehicle equipped with Topcon products, read and understand the following product specific
safety precautions in the Operator’s Manual for the equipment.
Safety for this Installation
CRITICAL: Before starting any work on the vehicle
Shut down the vehicle as per the manufacturer’s operator’s guide.
Allow the machine to cool before working on the machine.
Remove the ignition key to prevent accidental starting of the machine.
CRITICAL: Practice safe workshop practices
Clean the machine and target work areas thoroughly before commencing any work on the vehicle to
prevent contamination of hydraulic and electrical systems.
Wear appropriate clothing and footwear protection.
Do not perform the installation alone. Have someone with you to assist.
Dispose of any oil, coolant or machine fluid as per local laws and legislation.
Manually secure any machine components that must be raised, worked under, worked around or removed
as part of the installation or service procedure.
Never work on, adjust, lubricate or perform maintenance on a vehicle that is in motion or has powered
moving parts.
Keep all vehicle parts in good working order. If damage is found, report damage to the vehicle owner and
your manager immediately.
For self-propelled machines equipped with an electrical system, disconnect the negative (-) and positive
(+) battery terminals before performing electrical system service and maintenance or welding on the
vehicle.
To Next Page
Loading...
