Need help?Do you have a question about the Topcon X30 and is the answer not in the manual?
General| Display Size | 12.1 inches |
|---|---|
| Display Type | Touchscreen |
| Operating System | Windows CE |
| GPS | Yes |
| ISOBUS Compatibility | Yes |
| GPS Accuracy | 2 cm |
| Connectivity | Bluetooth, Wi-Fi, USB |
| Guidance Modes | Curve |
Outlines terms of use, copyright, trademarks, and general conditions.
Critical safety warnings and precautions for product operation.
Details warranty coverage for electronic and mechanical components.
Enables ISOBUS Universal Terminal server for interaction with the Athene ECU.
Creates a new implement profile for the attached implement.
Sets implement measurements for accurate guidance.
Configures section control for the implement.
Configures master switch and speed settings.
Explains navigation between the console's setup and operation screens.
Guides on how to access and view the Athene Universal Terminal window.
Displays job information and available operational buttons.
Configures the measurement units (metric or imperial) for the system.
Sets up the system to communicate with load cells.
Guides through calibrating load cells for accurate weight measurements.
Sets the full working width of the spreader for accurate coverage.
Configures the pre-start function for consistent coverage.
Instructions on how to activate and use the pre-start function.
Slows spinner RPM to reduce spread width at field boundaries.
How to activate and use the boundary reduction feature.
Stores and configures details for up to 10 different products.
Configures system alarms for conditions like RPM, level, and weight.
Configures the system's forward speed signal.
Performs an automatic calibration for the Speed Sensor Factor.
Allows operation with a simulated speed if the sensor fails.
Manages product loading and tare functions.
Procedures for adding product and taring with load cells fitted.
Procedures for adding product and taring without load cells.
Describes Dynamic and Static modes for product calibration.
Automatic, on-the-move calibration suited for variable density products.
Procedure for calibration, applicable to non-load cell systems and Dynamic mode.
Routine to establish the flow factor for product inconsistencies.
Fine-tunes calibration factor for product density discrepancies.
Calibration using a 'Static Test' routine for consistent product density.
Sets minimum and maximum PWM for spreader belt movement.
Guides on enabling and opening the Auto Section Control mini-view.
Explains the function and readiness indicators of the spreader master switch.
Setup and operation of Variable Rate Control (VRC).
Instructions for importing and using VRC prescription maps.
To Next Page
