Topcon X30 - Setting up the Section Switch

2.4. Setting up section control
12
2. Use a stop watch to time the delay between switching a section on
and the application of product. This is the ONTIME.
3. When the section is switched off, time the delay between
switching it off and the product ceasing to flow. This is the OFF
TIME.
To set the response times:
1.
Select Implement / Section Control / Timing .
2. Select ON TIME to set how many seconds delay there is between
switching a section on and the application of product, then
confirm.
3. Repeat for OFF TIME and confirm. This will set how many
seconds delay there is between switching a section off and
stopping product flow.
2.4.3. Setting up the section switch
The section switch option is not functional when using spreader
implements.