TOPP S80 Series User Manual

7- MAINTENANCE
BEFORE USING THE ACTUATOR, IT IS COMPULSORY FOR THE USER TO READ AND UNDERSTAND IN ALL ITS PARTS
THIS MANUAL,AS WELLAS THE EVENTUAL MANUAL OF THE INSTALLED CONTROL DEVICE TYPE.
6.1- USE OF THEACTUATOR
BEFORE OPERATING THE ACTUATOR, THE USER MUST COMPULSORILY VERIFY THAT NEAR AND/OR UNDER THE
WINDOW THERE ARE NOT ANY PERSON,ANIMALAND THING WHOSE SAFETY MAY BE ACCIDENTALLY JEOPARDISED
(SEE PAR.4).
DURING THE OPERATION OF THE ACTUATOR CONTROL DEVICE, THE USER HAS TO COMPULSORY OCCUPY A SAFE
CONTROL POSITIONASSURING VISUALCONTROLONTHE WINDOW MOVEMENT.
THE ACTUATOR CAN BE USED EXCLUSIVELY BY AN USER ACTING IN COMPLIANCE WITH THE INSTRUCTIONS
CONTAINED IN THIS MANUAL AND/OR IN THE MANUAL OF THE ACTUATOR CONTROL DEVICE (e.g.: WIND AND RAIN
CONTROL UNIT).
DO NOT OPERATE DOME WINDOWS IN THE PRESENCE OF A LOAD OF SNOW IN EXCESS OF THE QUANTITY
DECLAREDACCEPTABLE BY THE WINDOW MANUFACTURER.
IT IS COMPULSORYTO VERIFYCONSTANTLY IN TIME THE FUNCTIONAL EFFICIENCYAND THE RATED PERFORMANCE
OF THE ACTUATOR, OF THE WINDOW FRAME WHERE IT IS INSTALLED AND OF THE ELECTRIC PLANT, PERFORMING
WHEN NECESSARY INTERVENTIONS OF MAINTENANCE ASSURING OPERATION CONDITIONS COMPLYING WITH
SAFETY REGULATIONS.
LL ABOVE MENTIONED INTERVENTIONS CAN BE PERFORMED ONLY BY COMPETENT AND QUALIFIED TECHNICAL
PERSONNEL MEETING THE PROFESSIONAL AND TECHNICAL REQUIREMENTS FORESEEN BY THE LAW IN FORCE IN
THE COUNTRYOF INSTALLATION.
IN ORDER FOR THE AUTOMATION UNIT TO OPERATE CORRECTLY, WE RECOMMEND CARRYING OUT PERIODICAL
MAINTENANCE ON IT,AS INDICATED IN PAR.7.1 OF THIS MANUAL.
TOPP INFORMS THE USER THAT, IN ACCORDANCE WITH ART. 8 OF MINISTERIAL DECREE NO. 38 OF 22.1.2008, THE
OWNER OF THE SYSTEM IS RESPONSIBLE FOR ADOPTING ALL NECESSARY MEASURES TO MAINTAIN THE SAFETY
FEATURES SET OUT IN APPLICABLE LEGISLATION, OBSERVING THE INSTRUCTIONS FOR MAINTENANCE AND USE
PROVIDED BY THE MANUFACTURER OF THE DEVICEAND BYTHE COMPANY THAT CARRIED OUT THE INSTALLATION.
The use of the actuator allows to control automatically the opening and closing of the window according to the type of control
device installed (see par. 5. ).4
The Smart Reset System s integrated into the software of the electronic control board of actuator. This system adjusts
the closure of the window in a highly efficient fashion so as not to damage the window in any way. If you were to put an
obstacle in the way while the window is closing, the system would block the actuator(s) attached to the window to avoid
damaging it. If this happens in the last 50mm of the movement, which is below the allowable maximum overlap, you might
find that the window remains slightly open the next time it is closed. You only need to briefly open and close the window a few
times (about 4times) to activate the system and restore the window to its correct and proper closure.
i S80
THE MAINTENANCE OPERATIONS INVOLVING THE TOTAL OR PARTIAL DISMOUNTING OF THE ACTUATOR MAY ONLY
BE PERFORMED AFTER DISCONNECTING IT FROM THE POWER SUPPLY.
7.1- GENERAL INSTRUCTIONS
ANY WORK ON THE ACTUATOR (E.G.: POWER CABLE, ETC.) OR ITS COMPONENTS MAY ONLY BE CARRIED OUT BY
PERSONNEL QUALIFIED BY THE MANUFACTURER. TOPP DECLINES ALL LIABILITY FOR WORK PERFORMED BY
UNAUTHORISED PEOPLE.
IF THEACTUATOR WORKS INCORRECTLY, CONTACT THE MANUFACTURER.
18
INSTALLATION AND USE INSTRUCTIONS INSTALLATION AND USE INSTRUCTIONS
S80
6- USE AND OPERATION

TOPP S80 Series Specifications

General

Brand	TOPP
Model	S80 Series
Category	Controller
Language	English