TOPSKY DF02.01 - System Functions; Plug Detection; Reset to Factory Setting

7
• Once the display shows “E-3” and “rES”, it reminds you check whether any
motors fail connected with control unit. Please connect the main cable again,
wait at least 5 seconds.
1.
The function can detect whether the motors are
collected normally.
● Plug detection
• Connect all the plugs.
2.
• Follow manual reset procedure.
3.
Instruction
E-3
rES
rES
• Keep pressing “M” till the display shows “FAC”.
1.
With this function, you can make the control unit
to factory setting.
● Reset to factory setting
• Press “M”, and the control unit to factory setting (including memory position,
container and self-stop position, etc).
2.
• Press "M" the height has been changed to defined digit.
5.