Torbal ATN60A User Manual

ATN60A | AT110A
1. Carefully remove the scale, pan, and all components out of the
packaging. Place them on a stable surface where the scale will not be
compromised by any mechanical vibrations or high air movements.
Getting Started
2. Firmly screw in the chamber posts into the screw hole
openings located in the corners of the scale’s top housing.
3. Place the chamber top frame on the
posts and firmly secure it in place by
screwing in the post crews with the
provided wrench.
4. Install the back-chamber glass by inserting the
bottom edge into the scale housing (C’) and
securing the top edge in the chamber top
frame (C’’).
5. Install the left and right chamber access door
by sliding it into the scale housing and the
chamber top frame (C’’’).

Torbal ATN60A Specifications

General

Brand	Torbal
Model	ATN60A
Category	Scales
Language	English

Summary

Getting Started

Initial Chamber Assembly

Unpacking the scale, installing chamber posts, securing the top frame, and installing back and side chamber glass.

Completing Chamber and Pan Installation

Final Chamber and Pan Setup

Installing front and top chamber glass, chamber base, draft ring, pan support, and the pan.