How to fix Torin Jacks that will not lower?
If your Torin Jacks won't lower, it could be that the oil reservoir is overfilled. In this case, drain the excessive oil and lubricate the moving parts. It's also possible that the jack is binding or there's a foreign obstruction.
What to do if my Torin TA91206 won't lift load?
If your Torin Jacks won't lift the load, several factors could be at play. First, make sure the release valve is completely closed by turning the handle clockwise. It's also possible the weight capacity has been exceeded. Air in the hydraulics can also prevent lifting, so try purging the air from the system. Check the oil level and add oil if it's low. Lastly, a malfunctioning power unit may be the cause, requiring replacement.
Why is my Torin TA91206 lifting poorly?
Poor lifting performance in Torin Jacks can stem from a few issues. Air in the hydraulic system could be the culprit, so try purging it. Also, check the oil level and add oil if necessary. If those don't solve the problem, the power unit might be malfunctioning and need replacement.
What to do if my Torin TA91206 Jacks won't hold load?
If your Torin Jacks won't hold the load, it may be due to a low oil level, so add oil as needed. Alternatively, the power unit might be malfunctioning and require replacement.
Why won't my Torin TA91206 lift to full extension?
If your Torin Jacks isn't reaching its full extension, the oil level might be low, so add oil as required. Another possibility is a malfunctioning power unit that would need to be replaced.
Operators must read manual, be trained, use only genuine parts, and maintain equipment safely.
Ensure operators are trained and understand the manual; keep bystanders at a safe distance.
Jack is for lifting only; vehicle must be supported by jack stands after lifting.
Use only ASME-standard jack stands; do not use wood blocks for support.
Position jack on approved lift points on hard, level surfaces with minimal slope.
Use jack stands for support, chock opposing wheels, center loads, and never use jack to stabilize.
Block wheels, set parking brake, position jack on lift points, assemble handle, close release valve.
Remove jack stands, grasp handle firmly, slowly open release valve, retract ram.
Use only anti-foaming hydraulic jack oil; do not use motor oil, brake fluid, or other fluids.
Details causes and solutions for issues like valve not closed, overload, air in hydraulics, low oil, overfilled reservoir, and power unit malfunction.
To Next Page
General