3. Press the programming button (PROG button) (D).
The display shows “8”.
Menu 8:
Door adjustments
1. Select menu item “8”.
After about 2 seconds the display blinks and the set value time appears.
At delivery, the factory setting is ‘4’.
For optimal movement and to maintain the forces, the corresponding door type must be selected.
2. If desired, adjust the setting with the aid of the OPEN (B) and CLOSE (C) buttons.
Menu value Door type
0 Double swing gate
1 Non-swinging door, Canopy
2 Swing door, Kipptor normal
3 Swing door, tilt sensitive running
4 Universal setting (factory)
5 Sectional door with tension spring tting (Topspeed)
6 Sectional door with torsion spring tting (Topspeed)
7 Industrial door with standard ttings
8 Side section door (Topspeed)
9 Side section door with secondary closing edge
3. Press the SAVE button (D).
The display shows “9”.
Menu 9:
Adjustment other operating modes
1. Select menu item “9”.
After approximately 2 seconds, the display ashes and shows the set value of the operating mode.
The factory setting is "0”
To Next Page
Loading...
