104
Pivot the jig so you create the
shape of the edge.
Watch that you do not grind too
much on the long point.
This is a suitable shape (full
scale) for a 19 mm (¾") oval
skew.
Turn the jig around and shape
the other side.
Principle of creating the curve
Pivoting the jig on the bevelled
corner of the jig (A) creates the
curve. Do not turn the jig more
than the max. shown so the
seat rests on the Universal Sup-
port all the time.
Shaping and sharpening
Grind until the bevels are symmetrical. If necessary, grind the first
side again.
Move the Universal Support to
the honing wheel and position
identically with the Setter.
Hone both the sides alternately until the burr is removed and the
bevels are polished to a mirror finish.
Honing
To Next Page
Loading...
