tormek SVS-50 - Carving Gouges with Straight Shanks; Using the Open Seat for Straight Shank Gouges; Shaping the Edge of Carving Gouges

108
The Open Seat is Used
The Principle
Use the technique as described in the chapter Sharpening Techniques for Carving Gouges
and V-tools on page 20.
Edge Angle
As described in the chapter above on page 24, the choice of edge angle is very important
for a carving gouge. The method of setting the jig for a certain angle depends on whether you
want to replicate an existing edge angle or if you want to put a new edge angle on your tool.
When replicating an existing edge angle, you should use the Marker Method, which is de-
scribed on page 41. If you want to put a new edge angle to your tool, you can either set
the angle by eye or you can use the AngleMaster (page 142).
Shape the edge by resting the
tool on the Universal Support
placed horizontally and close
tothe wheel.
Flatten and smooth the blunt
edge with the fine side of the
Tormek Stone Grader, SP-650.
The blunt edge now appears
as a line of light, which is your
guide on where to grind.
Shaping the edge
Line of light
Carving Gouges with a Straight Shank