8
MAINTENANCE
Once a month remove the motor cover and vacuum out any dust or debris which has accumulated on
the motor. Replace the motor cover by setting it overt the holes in the housing and replace all of the
screws. Check and maintain the tightness of all the fasteners.
WARNING: Do not over-tighten the switch housing screws.
Keep the machine clean especially at the handle tube and collar so the handle tube will move
freely through the collar. Inspect the cord for cuts, gashes, or loose prongs; replace as needed.
Disassembly of this motor voids the warranty. Improper disassembly and assembly of this motor can
permanently damage the eld or rotor.
TROUBLESHOOTING
Problem Possible Cause
Machine will not start
Circuit breaker has tripped (Allow the
circuit breaker 2 minutes to cool before
resetting).
Circuit breaker will not reset. Replace.
Switch is defective. Replace.
Cord is damaged. Replace.
Plug is broken or has a loose contact.
Replace.
Machine will not reach operating speed
Over drawn circuit. Unplug anything other
than the machine from the circuit or locate
another circuit.
Motor runs but pad or brush does not turn Coupling is broken. Replace.
To Next Page
Loading...
Need help?
General
