6
Install (2) 12-volt or (4) 6-volt batteries. New bat-
teries should be given a full charge before rst use.
Limit use of new batteries during rst 5 cycles.
1. Place batteries alongside machine.
2. Recovery tank must be empty. Lift the top
cover to the open position.
3. Place batteries in tray. If you use (2) 12-volt
batteries, position on rear of tray. Use the brace to
secure them.
4. Position them correctly.
.
5. Follow the diagram inside the top cover and
connect all cables.
6. Spray each post with a protective lubricant.
Place battery terminal protectors over all posts
How To Install Batteries
CAUTION: Batteries are heavy. Use 2
people and lift them to avoid injury.
CAUTION: Make sure you connect RED (+)
cable terminals to positive (+) posts and BLACK
(-) cable terminals to negatve (-) posts. Machine
will not operate if not connected properly. Failure
to do so will result in damage to batteries and
possible explosion.
WARNING: Battery acid can cause severe burns. Wear pro-
tective goggles, face shield, gloves, and clothing BEFORE
lling or chargng batteries.
To Next Page
Loading...
Need help?
General
