Tornado 99130 User Manual

7
NOTE: Give all new baeries a full charge before they
are used.
NOTE: Limit extended use of new baeries during the
rst 5 operang cycles.
NOTE: Do not excessively discharge baeries.
Excessive discharge can cause polarity reversal and
complete failure of baery.
NOTE: Make sure the recovery tank is empty before
charging baeries.
•
Openmachinetop.
• Useammoniatedwindowcleanerandspray
topofbaeries.Useaclothandwipethe
baerytopstoremoveandcleanupspills.
CAUTION: BEFORE charging baeries, put
machine in a venlated area and always
leave machine top open.
CAUTION: Only use a baery charger
designed for the machine. Failure to do so
can result in damage to the baeries. The
charger was pre set at the factory for the
conguraon of your unit. If another type
of baery is installed the charger will have
to be programmed to match the baeries
that are being installed. Please see page
10 for charger programming instrucons
How to Charge Batteries
•
PlugthechargerACcordintoagrounded
walloutlet.Thechargerwillautomacally
begintochargethebaeries.
• Aerbaeriesarechargedunplugthe
chargerfromthewalloutlet.
• Closetopcoverofthemachine.
How To Install The Squeegee
1
PutSqueegeeposionleverintheUPand
lockedposion.
2 Posionthesqueegeebladeassemblyon
theswingarm.Makesuretheguidewheels
facetherearofthesqueegee.
3 Tightenthe2thumbscrews.
4 Placethesoluonrecoveryhoseoverthe
nozzle.Makesureittsght.

Tornado 99130 Specifications

General

Brand	Tornado
Model	99130
Category	Floor Machine
Language	English