11
How to Assemble and Operate the Vacuum
How to Attach the Handle to the Vacuum Cleaner
The vacuum cleaner and the handle are packed separately.
1. After rst removing the handle screw, insert handle
into the hole on top of the vacuum cleaner. (Fig. 4)
2. Line up the small hole on the handle with the small
hole on the vacuum cleaner and insert the screw.
Make sure the screw is secured tightly.
How to Operate the Vacuum Cleaner
1. To turn the vacuum on, push the switch located
on the rear of the unit to the ( I ) position. (Fig. 5)
2. To turn the vacuum off, push the switch located on
the rear of the unit to the ( O ) position.
Fig. 4
Fig. 5
How to Change the Vacuum Bag
Always operate the vacuum cleaner with a vacuum bag
installed.
How to Change the Vacuum Bag
1. Unplug the vacuum cleaner. Remove the bag
compartment cover and
remove the used bag from the bag holder (Fig. 7).
2. Attach the new vacuum bag onto the bag holder (Fig. 8).
3. Pull the bottom corners of the new vacuum bag (Fig. 9).
4. Reinsert the tab on the end of the bag compartment
cover into the grove
on the bag compartment housing. Press it into place and
fasten the bag
compartment tightly (Fig. 10).
Fig. 7 Fig. 8
Fig. 9 Fig. 10
NOTE: The brush motor is only activated when the handle is
moved back to the working position.
To Next Page
Loading...
Need help?
General
