13
Filters
Your Tornado vacuum cleaner is equipped with an exhaust lter and a HEPA lter.
These lters capture ne dust particles and protect the motor from dirt. It is important
to replace the HEPA lter approximately every six months.
To Change or Clean the Exhaust Filter
1. Unplug the vacuum cleaner. Remove the bag compartment cover and the bag.
2. Remove the exhaust lter and shake or brush off the dirt (Fig. 16) then replace
lter.
3. Replace the bag and bag compartment cover.
To Change the HEPA Filter
1. Unplug the vacuum cleaner. Remove the bag compartment cover.
2. Remove the HEPA lter from the front of the bag compartment. (Fig. 17)
3. Insert a new lter and replace the bag compartment cover.
Note: HEPA lters cannot be washed and used again
Fig. 17
Fig. 16
Self-Adjusting Brush Head
Your Tornado upright vacuum cleaner is designed with a Self-Adjusting Brush Head. No manual adjustments are required.
The height of the brush head is instantly adjusted to carpet pile height. This self-adjusting feature allows the brush head to
oat evenly over all carpet pile surfaces.
On-Board Tool Cleaning
This vacuum is equipped with on-board cleaning tools
including a
metal telescopic wand, stretch hose, dusting brush and
crevice tool.
1. To use the cleaning tools, lift the hose handle straight up
from
the vacuum (Fig. 18).
2. Extend the wand by pushing the button forward and
pulling the
smaller wand out of the larger wand (Fig. 19).
3. Attach any of the on-board tools to the end of the wand
or if you
do not need the wand, any tool can be connected
directly onto
the hose handle.
4. Position the vacuum cleaner handle in the upright
position and
turn the ON/Off switch to the ON position (I).
Fig. 19
Fig 18
To Next Page
Loading...
Need help?
General
