8
HOW TO OPERATE THE MACHINE
Plug the machine in as directed and lower the handle to
the desired operating height. Push the safety switch
forward
(see figure 4) and squeeze the switch triggers
beneath the handle grips. This activates the motor and
stars the pad in operation. Each time your release the
triggers the safety switch will reset. You will need to
follow the direction above to restart the machine.
CAUTION: When leaving the machine unattended,
disconnect the wall plug and return the handle to the
“locked” upright position to prevent accidental
starting.
Push the machine forward in a straight line, at a slow
walking speed. Overlap each pass by about 1 inch
(25mm).
AFTER USING THE MACHINE
Upon completion, dust mop with treated mop to pick up
all burnishing residue.
The condition of the oor pad has a direct effect on the
performance of your burnisher. When the pad becomes
dirt, turn it over and use the other side. When finished,
wash the pad out and allow it to dry completely before
using again.
TRANSPORTING THE MACHINE
Use the rear wheels for transporting the P1600 and
P2000 Glazers. This will insure that the operating
wheels remain clean and smooth for use on clean oor
surfaces (see gure 5).
gure 2
gure 3
gure 4
gure 5
https://harrissupplyind.com - To Order Parts Call 608-268-8080
To Next Page
Loading...
Need help?
General
