What to do if the vacuum motor runs but there's poor suction in my Tornado Marathon 800?
If the vacuum motor runs but suction is poor on your Tornado Floor Machine, first, remove any debris from the vacuum shoe or suction hose. Also, ensure that the recovery tank isn't too full; if it is, drain it.
How to troubleshoot no power on a Tornado Marathon 800?
If your Tornado Floor Machine has no power and nothing works, start by plugging in the cord. Then, check for any loose wiring.
What to do if the brush does not rotate on my Tornado Marathon 800?
If the brush on your Tornado Floor Machine isn't rotating, try resetting the circuit breaker and activating the brush switch. Also, check for loose wiring.
Why vacuum motor will not run on my Tornado Floor Machine?
If the vacuum motor on your Tornado Floor Machine won't run, first activate the vacuum switch. Then, check for loose wiring.
How to fix poor water spray on a Tornado Floor Machine?
If your Tornado Floor Machine has poor water spray, the spray jets might be clogged. Remove and clean the spray jets. Also, check the pump by removing the spray jets and checking the water flow.
Details warranty periods for tanks, bodies, parts, labor, and batteries.
Instructions to fill out and mail the warranty card.
Lists recommended commercial low foam cleaning chemicals for carpet extraction.
Explains grounding requirements and adapter use for safe electrical connection.
Describes the three main switches and circuit breaker for controlling the machine.
Step-by-step guide for preparing and operating the carpet rinser/dryer.
Steps for daily cleaning of the recovery tank, solution tank, and vacuum shoe.
Recommendations for monthly flushing and general inspection of components.
Instructions for winterizing the machine using antifreeze solution.
Lists common problems and their potential solutions for the machine.
Provides a list of part numbers and their descriptions for ordering replacements.
General| Brush Motor | 0.75 HP |
|---|---|
| Weight | 280 lb (127 kg) |
| Brush Speed | 200 RPM |
| Cleaning Path | 510 mm |
| Power Cable | 10 m |
| Cable Length | 10 m |
To Next Page
