MAINTENANCE AND LUBRICATION
13 (64)
TKU--- C 01140--- 1 EN 0404
D If welding must be done close to any of the control modules, disconnect the module
wiring before beginning welding.
D The ground cable of the welding m achine must be connected a s close as possible
to the welding location. The ground cable may not be connected so that the current
can flow through a bearing, joint coupling, sealing surface, lever, or control cable.
D Use a protective m ask when welding.
D Arrange adequate ventilation.
D Arrange protection against fire.
Maintenance
Manual
Maintenance
Manual
Operator's
Manual
Operator's
Manual
Maintenance
Manual
Maintenance
Manual
Workshop
Manual
Workshop
Manual
Spare Part
Manual
Spare Part
Manual
To Next Page
Loading...