MAINTENANCE AND LUBRICATION
15 (64)
TKU--- C 01140--- 1 EN 0404
2.5.5. Axles
Classification MIL--L--2105 C or API GL--5 + LS (Limited Slip)
Viscosity above --25 _C. SAE 80W/140
-- 2 5 _C...+15 _C SAE 85W/140
2.5.6. Grease nipples
Lithium--based greases with penetration 265/295 (NLGI 2) and dropping point 180 _C
should be used.
2.6. Filling capacities
Engine oil 29 L (with filters)
Engine coolant 55 L
Transmission 72 L
Transfer gearbox 9 L
Axles 2 x 44 L
Hydraulic oil tank 250 L
Fuel tank 310 L
2.7. Special notes
If the machine is fitted with optional equipment such as an automatic central lubrication
system, please r ead the instructions for the additional equipment carefully and adhere to
the service schedule given in the maintenance instructions.
2.7.1. Cooling system
D Drain and clean if the engine overheats or solution is dirty.
Note! Overheating indicates a fault. Stop the engine and repair the fault before more
serious damage is caused. Make sure that the engine radiator is not covered and that it
is not clogged.
D Whenever draining and refilling the cooling system, always r echeck the coolant
level after the engine reaches its normal operating temperature.
Note! Never open the filler cap when hot.
When checking engine coolant level, stop the engine and allow it and the radiator to cool
down. If an overheated engine must be stopped, allow the radiator to cool down before
checking the coolant level. If there is no time for that, use thick gloves and protective
clothing when opening the radiator’s filling cap. Stand to the side, turn your face away, and
open the cap a little. Wait until the pressure is released and coolant stops running out, then
open the cap slowly.
D Adding over 19 liters per minute can cause air pockets in the cooling system.
D Operate with a thermostat in the cooling system all year round.
D Coolant must be tested every 250 hours to ensure that inhibitor levels remain within
the permitted ranges; change the coolant inhibitor filter element if necessary (see
Detroit Diesel Coolant Selections or Engine Operator’s Guide).
Maintenance
Manual
Maintenance
Manual
Operator's
Manual
Operator's
Manual
Maintenance
Manual
Maintenance
Manual
Workshop
Manual
Workshop
Manual
Spare Part
Manual
Spare Part
Manual
To Next Page
Loading...