MAINTENANCE AND LUBRICATION
16 (64)
TKU--- C 01140--- 1 EN 0404
2.7.2. Refueling
The following precautions must be observed when adding fuel:
D Do not fill the fuel tank when the engine is running.
D Do not overfill.
D Take care not to spill fuel on hot surfaces.
D Addition of fuel should be done in a well--ventilated space.
D Smoking, open flames, and sparks ar e dangerous when the fuel tank is being filled.
D Clean up spilled fuel before starting the engine.
D Keep the filling pipe in contact with the fuel tank, or arrange grounding to pr event
sparking caused by static electricity.
D If fuel quick fill system is to be used, ensure that you are familiar with the system
manufacturer’s operating and safety requirements.
2.8. First servicing
Check that the lubricants being used meet site--specific operating requirements a s per
Sandvik Tamrock Lubricant Specifications.
The following steps should be carried out during the first week of use (in addition to the
normal, scheduled services):
After the first 50 hours
-- Change the transmission oil filter element
-- Change transfer gearbox oil
-- Change engine oil and filter elements
-- Check and tighten the exhaust manifolds’ bolts
-- Check that the air filter and air pipes are tight
-- Check and tighten bolts of oil sump and engine mountings
-- Check/tighten bolts of the axles, wheels, gearbox, and other major components
-- Tighten the screws of the oscilla ting axle
M12 bolts to 80 Nm (dry)
M16 bolts to 210--240 Nm (dry)
-- Tighten the screws of driveshafts
-- Check V--belts
-- Make a visual overall check for leaks and possible damage
Maintenance
Manual
Maintenance
Manual
Operator's
Manual
Operator's
Manual
Maintenance
Manual
Maintenance
Manual
Workshop
Manual
Workshop
Manual
Spare Part
Manual
Spare Part
Manual
To Next Page
Loading...