51 (64)
MAINTENANCE PROGRAM
TKU--- C 01140--- 1 EN 0404
Every 250 hours 2/2 Page
Done
Fill fuel tank 22..........................................................
Fill the automatic central lubrication tank (option) 23..........................
Grease lift cylinder pins, tilt cylinder pins, and lift arm pins* 23.................
Grease ejector cylinder pins (option) 24.....................................
Grease side tipping cylinder pins (option) 24.................................
Grease center articulation, steering cylinder pins, and oscillating axle* 24.......
Grease dogbone pins 23..................................................
Grease driveshafts 28....................................................
Grease the stationary ends of boom/bucket pins 34..........................
Lubricate operator seat linkages 33........................................
Lubricate door and hatch hinges 33........................................
Check center articulation 33...............................................
Wash radiator + oil coolers 25.............................................
General cleaning 27......................................................
Check r em ote control system (option) 24....................................
Check fire suppression system 34..........................................
* if automatic central lubrication is not installed
When completed
Date Engine hours....................... ................
Special Notes
Approved ............................
Maintenance
Manual
Maintenance
Manual
Operator's
Manual
Operator's
Manual
Maintenance
Manual
Maintenance
Manual
Workshop
Manual
Workshop
Manual
Spare Part
Manual
Spare Part
Manual
To Next Page
Loading...