Toro 02656 - Checking the Engine Oil Level; Adjusting the Cutting Height

CheckingtheEngineOilLevel
ServiceInterval:Beforeeachuseordaily
1.Removethedipstickandwipeitwithacleancloth.
2.Fullyinsertthedipstick.
3.Iftheoillevelislow ,slowlypouroilintotheoilll
tube,wait3minutes,andchecktheoillevelonthe
dipstickbywipingthedipstickcleanandtheninserting
thedipstickintothetube(
Figure10).
g018154
0.15 L
1
2
Figure10
1.Full2.Add
4.Filltheenginewithoiluntilthedipstickindicatesthat
theengineoilleveliscorrectasshownin.Ifyou
overlltheenginewithoil,removetheexcessoilas
directedinChangingtheEngineOil(page15)..
5.Installthedipstickandtightenitsecurely.
Important: Change the engine oil after the r st 5
operating hour s ;changeityearlythereafter.Refer
toChangingtheEngineOil(page15).
AdjustingtheCuttingHeight
WARNING
Adjustingthecuttingheightmaybringyouinto
contactwiththemovingblade,causingserious
injury.
•Stoptheengineandwaitforallmovingparts
tostop.
•Donotputyourngersunderthehousingwhen
adjustingthecuttingheight.
CAUTION
Iftheenginehasbeenrunning,themuferwillbe
hotandcanseverelyburnyou.Keepawayfromthe
hotmufer.
Toadjusttheheightofcut:
1.Griptheleverandpullsidewaystodisengageitfrom
thelockingnotch(Figure11).
g018156
1
Figure11
1.Height-of-cutadjustinglever
2.Pushitforwardstolowerorpullitbackwardstoraise
theheightofcut(Figure11).
3.Releasetheleverattherequiredpositionandensure
thatitlocksrmlyintooneoftheeightsettingnotches
(Figure11).
10