Toro 04130 - Setup; Loose Parts Chart

10
Setup
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts Chart
Note: Use this chart as a checklist to ensure all parts necessary for assembly have been shipped. If any of these parts are
missing, total setup cannot be completed.
Loose Parts Qty. Where Used
Handle Assembly 1 Install on machine. (Mounting fasteners loosely
installed on mower.)
Throttle stop
Wire retainer
Retainer screw
Retainer nut
1
1
1
1
Mount throttle wire
Cotter pin
Washer
Spring
1
1
1
Mount clutch rod
Gauge Bar Assembly 1 Use to set height-of-cut.
Machine Screw 10-32 x 0.88 in. (22 mm) 1 Install in gauge bar.
Jam Nut 10-32 1 Install on machine screw.
Grass Basket 1 Install on machine.
EEC Noise Certification 1
Operator’s Manual 1 Read before operating machine.
Operator’s Video 1 View before operating machine.
Engine Operator’s Manual 1
Parts Catalog 1