EasyManua.ls Logo

Toro 07264 - User Manual

Toro 07264
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Form No. 3356-911 Rev B
Workman® 1110 Utility Vehicle
Model No. 07264 —Serial No. 270000001 and Up
Model No. 07264TC —Serial No. 270000001 and Up
Register your product at www.Toro.com Original Instructions (EN)

Table of Contents

Questions and Answers

  • C
    Crystal YoderAug 12, 2025
    What to do if my Toro 07264 Automobile does nothing when I try to start it?
    • L
      Lauren FloresAug 12, 2025
      If nothing happens when you try to start your Toro Automobile, several issues could be the cause. The battery might be dead, requiring a recharge or replacement. The wiring to the start circuit components, battery cables, or the battery ground to the frame could be loose, corroded, or damaged; inspect and repair as necessary, tightening or cleaning the connections. Other potential causes include a faulty fuse block (replace it), a loose or blown 10-ampere fuse to the ignition switch (check and replace it), a faulty ignition switch or starter solenoid (replace them), a faulty or misadjusted switch at the accelerator pedal (inspect, adjust, or replace it), or a faulty shutdown module (replace it).
  • R
    Ricky JohnsonAug 22, 2025
    Why does the starter solenoid click, but the starter won't crank on my Toro 07264?
    • D
      davidhessAug 22, 2025
      If the starter solenoid clicks but the starter won't crank in your Toro Automobile, the battery charge might be low, so you should check it. Also, the battery cables or the battery ground to the frame could be loose or corroded; in this case, tighten or clean the connections. Faulty wiring at the starter, a faulty starter solenoid, or a faulty starter causing an incomplete circuit for the solenoid could also be the reason; inspect and repair the wiring or replace the solenoid or starter.
  • R
    Randy SmithAug 31, 2025
    What to do if Toro 07264 engine cranks, but does not start?
    • M
      Mr. Christopher WintersAug 31, 2025
      If your Toro Automobile's engine cranks but doesn't start, it could be due to several reasons. The wiring to the start circuits might be loose, corroded, or damaged; inspect and repair it. A faulty shutdown module could also be the cause, so replace it if necessary. Additionally, the engine or fuel system might be malfunctioning (inspect them), or the engine and fuel may be too cold (warm them up).

Toro 07264 Specifications

General IconGeneral
BrandToro
Model07264
CategoryAutomobile
LanguageEnglish

Related product manuals