Toro 08720 - Installing Cam Brackets

g024658
Figure6
1.Cam
3.Flangebushing
2.Spacer(3/8x17/32inch)
3.Usetapeoramarkertomarktheexactlocations
ofthestopplates(Figure7).
Important:Ifthestopplatesarenotaligned
correctly,thecontrolhandlescouldoverload
theinputshaftsofthetransmissions.
g023557
Figure7
1.Bolt
2.Stopplate
4.Toaccessthemountingareaforthecams,
removetheboltsthatsecurethestopplatesto
theframe,andremovethestopplates(Figure
7).
Note:Retainthestopplatesandthebolts.
5.Aligntheleft-handcamtothetopholeinthe
left-handsideoftheframe,nearthecontrol
handle(Figure8).
g024657
Figure8
1.Locknut(3/8inch)3.Bolt(3/8x1-1/4inch)
2.Fenderwasher(3/8inch)4.Cam
6.Securethecamwitha3/8x1-1/4inchbolt,2
fenderwashers,anda3/8inchlocknut.
7.Repeatsteps5and6fortheright-handsideof
themachine.
4
InstallingtheCamBrackets
Partsneededforthisprocedure:
4
Bolt(5/16x3/4inch)
4
Flangenut(5/16inch)
2
Camspring
Procedure
1.Alignthemountingholesintheleft-handcam
bracketwiththemountingholesintheframe,
neartheinstalledcam(Figure9).
4