Toro 1800 Power Curve - Set-Up/Assembly Manual

1800 POWER CURVE
1Service Instruction TSN0001a
1. Stand the snowthrower on its wheels and position
the upper handle. Inspect the wiring for any signs of
damage. If any damage is found, do not assemble.
Contact an Authorized Service Dealer (Fig. 001 and
Fig. 002).
2. Insert the right side of the upper tubing over the
lower right side tubing (Fig. 003).
3. Insert the left side of the upper tubing into the lower
left side tubing (Fig. 004).
Fig. 001 PICT-1418
Fig. 002 PICT-1419
Fig. 004 PICT-1424
Fig. 003 PICT-1422
Upper Handle & Chute Crank Installation
1800 Power Curve Set-up / Assembly