EasyManua.ls Logo

Toro Power Max 1028LXE - User Manual

Toro Power Max 1028LXE
28 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
FormNo.3358-623RevA
PowerMax™1028LXESnowthrower
ModelNo.38640—SerialNo.270000001andUp
Operator'sManual
Introduction
Readthisinformationcarefullytolearnhowtooperate
andmaintainyourproductproperlyandtoavoidinjury
andproductdamage.Youareresponsibleforoperating
theproductproperlyandsafely.
YoumaycontactTorodirectlyatwww.Toro.comfor
productandaccessoryinformation,helpndinga
dealer,ortoregisteryourproduct.
Wheneveryouneedservice,genuineToroparts,
oradditionalinformation,contactanAuthorized
ServiceDealerorToroCustomerServiceandhave
themodelandserialnumbersofyourproductready.
Figure1identiesthelocationofthemodelandserial
numbersontheproduct.Writethenumbersinthe
spaceprovided.
Figure1
1.Modelandserialnumberlocation
ModelNo.
SerialNo.
Thismanualidentiespotentialhazardsandhas
safetymessagesidentiedbythesafetyalertsymbol
(Figure2),whichsignalsahazardthatmaycauseserious
injuryordeathifyoudonotfollowtherecommended
precautions.
Figure2
1.Safetyalertsymbol
Thismanualuses2wordstohighlightinformation.
Importantcallsattentiontospecialmechanical
informationandNoteemphasizesgeneralinformation
worthyofspecialattention.
Warning
CALIFORNIA
Proposition65Warning
Theengineexhaustfromthisproduct
containschemicalsknowntotheStateof
Californiatocausecancer,birthdefects,
orotherreproductiveharm.
ThissparkignitionsystemcomplieswithCanadian
ICES-002.
Theenclosed
Engine Owner’ s Man ual
issupplied
forinformationregardingtheUSEnvironmental
ProtectionAgency(EPA)andtheCalifornia
EmissionControlRegulationofemissionsystems,
maintenance,andwarranty.Replacementsmaybe
orderedthroughtheenginemanufacturer.
©2007—TheToro®Company
8111LyndaleAvenueSouth
Bloomington,MN55420
Registeratwww.Toro.com.
OriginalInstructions(EN)
PrintedintheUSA
AllRightsReserved

Table of Contents

Questions and Answers

  • J
    Jo MooreAug 21, 2025
    Why won't my Toro Snow Blower engine start?
    • W
      williamsaustinAug 21, 2025
      If your Toro Snow Blower engine won't start or starts hard, possible causes and solutions include: 1. Ensure the key is in the ignition and turned to the On position. 2. Move the choke to the On position and press the primer 3 times. 3. Open the fuel shutoff valve. 4. Move the throttle to the Fast position. 5. Drain and/or fill the fuel tank with fresh gasoline (not more than 30 days old). 6. Connect the wire to the spark plug. 7. Check the spark plug and adjust the gap if necessary. Replace the spark plug if it is pitted, fouled, or cracked. 8. Remove the vent restriction or replace the fuel cap. 9. Add or drain oil to adjust the oil level in the engine crankcase to the Full mark on the dipstick.
  • J
    John PattersonAug 25, 2025
    What to do if Toro Power Max 1028LXE does not discharge snow properly?
    • M
      Martha GuerreroAug 25, 2025
      If your Toro snowthrower isn't discharging snow well, consider these points: * Ensure the throttle is in the 'Fast' position when throwing snow. * Try shifting to a lower gear, as you might be moving too fast. * Reduce the amount of snow you're trying to clear in each pass. * Avoid overloading the snowthrower with extremely heavy or wet snow. * If the discharge chute is plugged, refer to Unclogging the Discharge Chute on page 15. * For issues with the auger/impeller drive belt (loose, off the pulley, worn, or broken), refer to www.Toro.com for servicing information or take the snowthrower to an Authorized Service Dealer.
  • J
    jennifer01Aug 26, 2025
    Why Toro Snow Blower engine runs rough?
    • R
      Renee FrederickAug 26, 2025
      If your Toro snow blower engine is running rough, it could be due to: the choke being in the On position (move it to the Off position), the fuel shutoff valve not being completely open (open it fully), stale fuel or a nearly empty fuel tank (drain and fill with fresh gasoline, not more than 30 days old; if the problem persists, contact an Authorized Service Dealer), or a loose spark plug wire (connect the wire to the spark plug).
  • A
    Angela JohnsAug 28, 2025
    What to do if Toro Snow Blower does not properly clear the snow off the surface?
    • C
      Christine BallardAug 28, 2025
      If your Toro snowthrower isn't clearing snow effectively, it might be because the skids and/or scraper aren't properly adjusted, so adjust them. Also, check the tire pressure and adjust if necessary to ensure it's even.
  • J
    joseph62Aug 30, 2025
    What to do if Toro Power Max 1028LXE Snow Blower engine runs rough?
    • U
      ubrownAug 30, 2025
      If your Toro Snow Blower engine runs rough, first ensure the choke is in the Off position and the fuel shutoff valve is fully open. Check that the fuel tank has fresh gasoline. Also, verify the spark plug wire is securely connected and the spark plug isn't damaged or improperly gapped. Finally, confirm the engine oil level in the crankcase is at the correct level, indicated by the Full mark on the dipstick.
  • J
    Jonathan DavisSep 1, 2025
    Why Toro Power Max 1028LXE Snow Blower discharges snow poorly?
    • R
      Regina ArellanoSep 1, 2025
      If your Toro snow blower isn't discharging snow well, ensure the throttle is in the Fast position. Avoid moving too quickly for the amount of snow, and reduce the amount of snow you're trying to clear per pass. Also, avoid trying to remove extremely heavy or wet snow.
  • C
    Carmen TateSep 3, 2025
    What to do if my Toro Power Max 1028LXE Snow Blower runs but doesn't throw snow?
    • G
      George WalkerSep 3, 2025
      If your Toro Snow Blower runs but doesn't discharge snow well, it could be due to several reasons: 1. Ensure the throttle is in the Fast position. 2. Shift the snowthrower into a lower gear. 3. Reduce the amount of snow removed per swath. 4. Avoid overloading the snowthrower with extremely heavy or wet snow. 5. Unclog the discharge chute.
  • A
    Alexander ClineSep 5, 2025
    Why is my Toro Power Max 1028LXE engine running rough?
    • J
      Jeremy MccannSep 5, 2025
      If your Toro Snow Blower engine is running rough, try the following: 1. Move the choke to the Off position. 2. Open the fuel shutoff valve completely. 3. Drain and fill the fuel tank with fresh gasoline (not more than 30 days old). 4. Connect the wire to the spark plug. 5. Check the spark plug and adjust the gap if necessary. Replace the spark plug if it is pitted, fouled, or cracked. 6. Add or drain oil to adjust the oil level in the engine crankcase to the Full mark on the dipstick.
  • K
    Kimberly MorenoSep 7, 2025
    What to do if my Toro Power Max 1028LXE doesn't clear snow off the surface?
    • T
      Tamara KellySep 8, 2025
      If your Toro Snow Blower isn't clearing snow properly off the surface: 1. Adjust the skids and/or the scraper. 2. Check and adjust the pressure in one or both tires.
  • M
    Madison McbrideSep 10, 2025
    How to fix electric starter that does not turn on Toro Power Max 1028LXE?
    • C
      cooperrebeccaSep 10, 2025
      If the electric starter on your Toro snow blower isn't turning, check the following: 1. Make sure the power cord is securely connected both at the outlet and to the snowthrower. 2. Inspect the power cord for any signs of wear, corrosion, or damage; replace it if necessary. 3. Verify that the power outlet is energized; if not, have a qualified electrician address the issue.

Summary

Safety

Before Operating

Read manual, understand controls, and know how to stop engine.

Training

Stresses proper operator training and prohibits use by untrained individuals.

Preparation

Steps to prepare the area and operator before snowthrower operation.

Operation

Clearing a Clogged Discharge Chute

Maintenance and Storage Notes

Toro Safety Information

Toro Snowthrower Safety

Setup

Installing the Upper Handle

Installing the Wheel Clutch Cable Ends

Installing the Traction Control Linkage

Installing the Chute Control Rod

Installing the Chute Control Rod

Connecting the Wire to the Headlight

Filling the Engine with Oil

Procedure for checking and adding engine oil.

Product Overview

Filling the Fuel Tank

Instructions for safely filling the fuel tank with gasoline.

Starting the Engine

Stopping the Engine

Operating the Traction Drive

Using the Wheel Clutch Levers

Operating the Speed Selector

Operating the Auger;Impeller Drive

Engaging and disengaging the auger/impeller drive.

Moving the Discharge Chute

Moving the Chute Deflector

Unclogging the Discharge Chute

Safe procedure for unclogging the discharge chute.

Preventing Freeze-up

Maintenance

Recommended Maintenance Schedule

Schedule for regular maintenance tasks and intervals.

Checking the Engine Oil Level

Checking and Adjusting the Skids and Scraper

Checking and Adjusting the Traction Cable

Checking and Adjusting the Auger;Impeller Cable

Checking the Auger Gearbox Oil Level

Changing the Engine Oil

Procedure for changing the engine oil.

Inspecting and Replacing the Spark Plug

Adjusting the Discharge Chute Latch

Storage

Preparing the Snowthrower for Storage

Steps to prepare the snowthrower for long-term storage.

Troubleshooting

Toro Power Max 1028LXE Specifications

General IconGeneral
BrandToro
ModelPower Max 1028LXE
CategorySnow Blower
LanguageEnglish

Related product manuals