Toro Power Max 1028LXE - Replacing the Drive Belts; Replacing the Headlight Bulb

Figure56
1.Dischargechutelatch
2.Gearteeth
Note:Thelatchisspringloadedandwillnaturally
moveintotheteethofthegear(Figure56).
4.Removeanyslackinthecablebypullingthecable
conduitrearward.
5.Tightentheboltonthecableclamp.
6.Installandsecurethegearcover.
ReplacingtheDriveBelts
Iftheauger/impellerdrivebeltorthetractiondrivebelt
becomesworn,oil-soaked,orotherwisedamaged,go
towww.Toro.comforadditionalserviceinformationor
haveanAuthorizedServiceDealerreplacethebelt.
ReplacingtheHeadlightBulb
UseaGE89216Whalogenlightbulb.Donottouch
thebulbwithyourhandsorallowdirtormoistureto
comeintocontactwiththebulb.
1.Removethewireconnectorfromthebackofthe
headlight(
Figure57).
Figure57
2.Turnthebaseofthebulbcounterclockwiseuntilit
stops(Figure58).
Figure58
3.Removethebulbstraightoutfromthebackofthe
headlight(Figure59).
Figure59
4.Insertanewbulbintothebackoftheheadlight
(Figure60).
Figure60
5.Turnthebaseofthebulbclockwiseuntilitissnug
(Figure61).
Figure61
6.Insertthewireconnectorstraightintothebackof
theheadlightuntilitissecurelyinplace(
Figure62).
24