Toro Power Max 1028LXE - Connecting the Wire to the Headlight; Filling the Engine with Oil

Figure16
1.Cableclip2.Deectorcable
7.HoldthebluetriggercapdownandrotatetheQuick
Stickinacircletoensurethatthechuteanddeector
operatesmoothly.
5.ConnectingtheWiretothe
Headlight
1
Cabletie
Procedure
1.Insertthewireconnectoronthelooseendofthe
wirestraightintothebackoftheheadlightuntilitis
securelyinplace(Figure17).
Figure17
1.Plasticcliponwire
connector
3.Cabletie
2.U-bolt
Note:Ensurethattheplasticcliponthewire
connectorisonthebottom(Figure17).
2.Secureacabletie(fromtheloosepartsbag)around
thewireandthehandleaboutaninch(2.5cm)below
theU-bolt(Figure17).
6.FillingtheEnginewithOil
Procedure
Yoursnowthrowercomeswith26oz.ofoilinthe
engine.
Note:Beforestartingtheengine,checktheoillevel
andaddoilifnecessary.
Max.ll:26oz.(0.77l),type:automotivedetergent
oilwithanAPIserviceclassicationofSF,SG,SH,SJ,
SL,orhigher.
•Fortemperaturesabove32°F(0°C),useSAE30W .
•Fortemperaturesbetween0°Fand32°F(-18°Cto
0°C),useSAE5W30orSAE10W .
•Forairtemperaturesbelow0°F(-18°C),use
SAE0W30.
1.Removethedipstickandslowlypouroilintotheoil
lltubetoraisetheoilleveltotheFullmarkonthe
dipstick.Donotoverll.(
Figure18).
Figure18
2.Installthedipsticksecurely.
Note:Donotspilloilaroundtheoillltube;oil
couldleakontotractionpartsandcausethetraction
toslip.
7.CheckingtheTirePressure
Procedure
Thetiresareoverinatedatthefactoryforshipping.
Reducethepressureequallyinbothtirestobetween17
and20psi(116and137kPa).
10