6
3350-635
Adjusting the Cutting Height
Caution
If the engine has been running, the muffler will be hot and can severely burn you.
Keep away from the hot muffler.
Adjust the cutting height
as desired. Set all four
wheels to the same
height.
1-5/8
1-1/4
2
2-3/8
2-3/4
3-1/8
3-7/8
4-1/4
3-1/2
m-5629
m-5605a
FRONT
m-5604a
Adjusting the Handle Height
Squeeze the bottom of
the handle halves
together (as shown) and
change the handle holes
in which the pins (A) are
mounted, as follows:
• Raise the handle
using hole (B).
• Lower the handle
using hole (C).
m-5612
m-5614
A
B
C
Operation
Starting the Engine
1. Firmly push in the
primer 3 times with your
thumb, holding the
primer in for a second
before releasing it each
time.
Note: If the air
temperature is below
55
°
F (13
°
C), firmly push
the primer in 5 times.
m-5572
2. Hold the blade
control bar (A) against
the handle.
A
m-5644
3. Start the engine using the recoil starter.
m-5645
4. If the mower does not start in 1 or 2 pulls, press
the primer button 1 or 2 times and try starting it again.
To Next Page
Loading...
Need help?
General
