Toro 20355 - Page 18

decal133-8198
Figure21
2.Ensurethatthecutting-heightsettingonthe
machineis35mm(1-3/8inches)orhigher;if
itisnot,lowerit;refertoAdjustingtheCutting
Height(page11).
3.Disengagethehandlelocks(Figure22).
g189218
Figure22
1.Handlelockengaged
position
2.Handlelockdisengaged
positions
4.Foldthehandlefullyforward(Figure22).
Important:Routethecablestotheoutside
ofthehandleknobsasyoufoldthehandle.
5.Engagethehandlelocks.
6.Liftthefrontofthemachinebythehandleand
moveitintoastoragespace(Figure23).
g189217
Figure23
18