Figure 6
1. Plastic clip (2)
4. Secure the bottom of the fuel tank to the
fuel tank brac k et b y installing the self-tapping
screws from the bottom. Do not o v er tighten
the scr ews.
Step
4
Installing the Discharge
Tunnel Plug
Parts needed for this step:
1
Discharge tunnel plug
Procedure
1. Open the disc harg e door b y pulling forw ard on
the handle and mo ving it rearw ard ( Figure 7 ).
Hold the disc harg e door handle to prev ent the
spring-loaded door from closing while y ou
inser t the plug .
Figure 7
1. Discharge door handle 2. Plug, rotated clockwise
2. Since the plug is slightly wider than the
disc harg e tunnel opening, rotate the plug
cloc kwise slightly while inser ting it ( Figure 7 ).
Note: Ensure that the ar ro w on the plug
decal points upw ard.
3. Push the plug all the w a y in until the spring clip
on the bottom of the plug clic ks into place ,
loc king the plug securely into the disc harg e
tunnel ( Figure 8 ).
Figure 8
1. Spring clip
4. R elease the disc harg e door handle to loc k the
top of the plug .
9
To Next Page
Loading...
