Toro 22303 - Assembly; Loose Parts; Installing the Valve Lever; Activating the Battery

8
Assembly
Loose Parts
Note: Use the chart below to verify that all parts have been shipped.
DESCRIPTION QTY. USE
T raction Unit
V alve Lever
1
1
Install valve lever
Key 2 Start engine
Installing the V alve Lever
1. Thread the lever into the speed selector valve
(Fig. 2).
Note: The lever should be installed with the
bend toward the operator.
2. Tighten the jam nut on the lever to lock it in
position.
1
m–3883
Figure 2
1. Speed selector lever
Activating the Battery
The traction unit is shipped with a dry battery. Bulk
electrolyte with 1.260 specific gravity must be
purchased from a local battery supply outlet.
1. Remove the four bolts securing the battery cover
and remove the cover (Fig. 3)
2. Remove the nuts and bars securing the battery
(Fig. 3).
2
5
3
m–4391
4
1
2
6
7
Figure 3
1. Battery cover
2. Bolt
3. Battery
4. Bars
5. Nut
6. Positive cable
7. Negative cable