26
Maintenance
Service
Interval Chart
8
Hours 25 Hours 75 Hours
150 Hours 400 Hours
Yearly/Storage
Grease the traction unit
Check engine oil level
Check radiator coolant level
Check for loose fasteners
Check tire pressure (20 psi)
Clean primary air filter
1
Check hydraulic oil level
Inspect hydraulic lines for leaks
Change engine oil
1,
2
Check
battery electrolyte level
Check battery cable connections
Check wheel lug nut torque (50 ft.-lbs)
3
Change engine oil filter (every other oil change)
1,
4
Check
engine speed (1300 rpm idle and 3700 full throttle,
±100)
Check fan belt and alternator belt tension
1
Change hydraulic filter
1,
3,
5
Inspect
fuel lines for leaks
Change hydraulic oil
1,
6
Replace
primary and secondary air filters
1
p
ep
ace t
e
ue
ter
Check radiator coolant protection temperature
7
T
ouch up chipped paint
1.
More
often in dusty
, dirty conditions.
2. Change oil after the first 50 operating hours.
3. Change the hydraulic filter and torque the lug nuts after the first 8–10 operating hours
4. For severe duty or rental applications, change every 75 operating hours.
5. For severe duty or rental applications, change every 150 operating hours.
6. For severe duty or rental applications, change every 400 operating hours
7. Flush radiator coolant system and replace coolant every two years.